产品中心
C-UV 913 Technical Data Sheet
产品介绍
C-UV913 is one component, epoxy UV cure, transparent, low viscosity with excellent water vapour barrier properties after cure. C-UV913 is designed to be used as a perimeter sealant in OLED and electrophoretic displays or any other type of display that requires protection against humidity. It is formulated to cure very fast upon exposure to UV light allowing very fast processing of a thin section of material even through ITO coated glass.
C-UV913 是一种单组分环氧树脂UV固化胶粘剂,透明而且粘度较低,在固化后具有卓越的水蒸气阻隔性能。C-UV913是被设计用来作为需要防湿的有机发光二极体及电泳显示器,或任何其他类型的显示器的周边密封胶,薄件材料曝露在UV紫外光下能非常快速的固化,在快速工艺下甚至能通过镀膜玻璃完成。
PROPERTIES OF UNCURED MATERIAL 固化前材料性能
Property性能 |
Test Method测试方法 |
Value数值 |
Color/Appearance 颜色/外观 |
Visual 目测 |
clear liquid 清澈液体 |
Viscosity 粘度, pa·s, 25 °C |
Brookfield 布氏粘度, #7,10 rpm |
0.5 |
Shelf life 储存期, month |
|
6(2-8℃) |
Cure Schedule : 固化进度表:
A minimum UV dose of 6,0 J/cm² is needed to fully cure the material. Using a typical UV lamp intensity
of 100 mW/cm², a full cure will take 60 seconds.Optimal product performance is reached after 24 hours at ambient conditions。
材料充分固化的条件是6焦耳每平方厘米,用一个典型的强度100毫瓦/平方厘米紫外线灯进行一个完整的固化时间将需要60秒。在室温条件下, 24小时之后达到最佳的产品性能。
DIRECTIONS FOR USE 使用指南
The adhesive can be hand applied from bottle, or dispensing systems are also available for high volume assembly applications.
该产品可手工从瓶中取出使用,对于大体积的装配生产可提供分散系统。
STORAGE INFORMATION储存方法
Storage below 2-8°C in the unopened container in a dry location, the shelf life is 6 months.
在2-8 ºC条件下密封干燥储存, 保质期为6个月
注意:用户具有决定产品的适用性和选择合适的使用方法的责任。
Note: The users have to determine the suitability of the products and choose the right using method of liability.